Life In Cobb County

Plumbing Tips & Tricks

Are You Embarrassed By Your Plumbing Skills? Tips and Tricks  To Help You Out.

Tips and Tricks for Weekend Plumbing

More than any other kind of home improvement work, plumbing can get a DIYer crazy. Difficulties arise, frustrations multiply, and projects grow. Even experts are not immune. One way to handle the frustrations and accomplish a successful plumbing venture is to allow a good amount of time—at least double the time as you feel the venture should take. Another intelligent step is to master some tricks of the craft. Allow me to share a couple of our favorites.

Reheat the Solder If You Unable to Cut a Pipe

The ideal way to detach a soldered pipe is by cutting it. But in some cases you can’t—either since you can’t have a cutting device into the space or when cutting may leave the pipe too limited to make a new connection. The remedy is by heating heat the joint and then complete the installation as the solder melts.

It’s important to have a wet rag ready and instantly clean away the molten solder just before it solidifies. (Wear safety gloves to avoid burning your fingers!) At times a fast wipe will leave the pipe all set for a fresh fitting. Very likely, you will need to scour off some extra solder with emery cloth or sand paper before you slip on a fresh fitting.

Use Plastic instead of   Metal Drain Lines

Metal drain lines beneath sinks look far more efficient than plastic. However plastic is much better in virtually every way. It’s less expensive, easier to mount, and less difficult to tighten or adjust if a leak builds up. And as opposed to metal, plastic won’t rust. So if a metal drain leaks, usually the best move is to swap the whole assembly with plastic.

Loosen Stuck Pipes with Heat

When a threaded link won’t budge, heat at times does the trick, particularly on old connections which were covered with pipe dope that solidified over time. Have patience. Getting the metal hot may take a handful of minutes. Protect close by surfaces with a flame resistant cloth. This technique is for waste pipes and water only, not for fuel or gas lines.

Piggyback Tenacious Shutoffs

Shutoff valves under toilets and sinks toilets have a rotten consistency record. At times they won’t close entirely; often they won’t close whatsoever. In any case, there’s a substitute to swapping the shutoff. Many home depots carry “piggyback” shut off valves which connect to active shutoffs. Just detach the supply line and mount the new valve. In case the old shut off closes almost all of the way, you won’t have to switch off the primary water valve instead set a container below the valve to capture the trickle as you work.

Fix a Clog in Seconds        

Before you operate a drain snake onto a blocked pipe or take down the trap, there`re some other tricks worth attempting: Frequently, you may yank out a blockage with a versatile-shaft pick up tool or a Zip-It. In the same way, a wet/dry vacuum might vacuum out the clog. Special thanks to the Kennesaw Plumbing Experts

Leave a Comment

Your email address will not be published. Required fields are marked *